wood milling cutter Introduction and purpose cutter

When optimizing the effect of the milling,  wood milling cutter blade is another important factor, if at any time while participating in the milling cutting insert more than one number is an advantage, but the drawback is that many also participate in the number of wood milling cutter blades, each of the cutting a cutting edge can not simultaneously cutting power required and to attend the cutting edge of flap abrasive cutting wheel the number of relevant, on chip formation, cutting edge loading and processing the results, the position of the workpiece relative to the cutter plays an important role. When face milling, cutting width with a ratio of about 30% larger cutter and the  wood milling cutter location close to the center of the workpiece, so little change in chip thickness. When the Leads Diamond Cutting Blades thickness of chip thickness ratio slightly thinner at the center of some of the cutting. Rough milling, removal of a large number of blanks, or the outline of a small area of ​​the horizontal plane finishing. For surface finishing and semi-finishing; small ball end mill can be as small chamfered surface finishing as well as irregular contours steep face / straight wall. Chamfer cutter with a flat head, do rough milling to remove a lot of blanks, but also fine milling of fine smooth surface (relative to the steep surface) small chamfer.